feat: 全量同步 254 个常用的 Arduino 扩展库文件

arduino-libs/arduino-cli/libraries/Esplora/examples/Beginners/EsploraLedShow2/EsploraLedShow2.ino

@@ -0,0 +1,55 @@
+/*
+  Esplora Led/Microphone
+
+  This simple sketch reads the microphone, light sensor, and slider.
+  Then it uses those readings to set the brightness of red, green and blue
+  channels of the RGB LED. The red channel will change with the loudness
+  "heared" by the microphone, the green channel changes as the
+  amount of light in the room and the blue channel will change
+  with the position of the slider.
+
+  Created on 22 november 2012
+  By Enrico Gueli <enrico.gueli@gmail.com>
+  Modified 24 Nov 2012
+  by Tom Igoe
+*/
+
+#include <Esplora.h>
+
+void setup() {
+  // initialize the serial communication:
+  Serial.begin(9600);
+}
+
+int lowLight = 400;   // the light sensor reading when it's covered
+int highLight = 1023; // the maximum light sensor reading
+int minGreen = 0;     // minimum brightness of the green LED
+int maxGreen = 100;   // maximum brightness of the green LED
+
+void loop() {
+  // read the sensors into variables:
+  int mic = Esplora.readMicrophone();
+  int light = Esplora.readLightSensor();
+  int slider = Esplora.readSlider();
+
+  // convert the sensor readings to light levels:
+  byte red   = constrain(mic, 0, 255);
+  byte green = constrain(
+                 map(light, lowLight, highLight, minGreen, maxGreen),
+                 0, 255);
+  byte blue  = slider / 4;
+
+  // print the light levels (to see what's going on):
+  Serial.print(red);
+  Serial.print(' ');
+  Serial.print(green);
+  Serial.print(' ');
+  Serial.println(blue);
+
+  // write the light levels to the LED.
+  // note that the green value is always 0:
+  Esplora.writeRGB(red, green, blue);
+
+  // add a delay to keep the LED from flickering:
+  delay(10);
+}