初始化提交

arduino-cli/libraries/IRremoteESP8266/examples/TurnOnFujitsuAC/TurnOnFujitsuAC.ino

@@ -0,0 +1,50 @@
+// Copyright 2017 Jonny Graham, 2018 David Conran
+#include <Arduino.h>
+#include <IRremoteESP8266.h>
+#include <IRsend.h>
+#include <ir_Fujitsu.h>
+
+const uint16_t kIrLed = 4;  // ESP8266 GPIO pin to use. Recommended: 4 (D2).
+IRFujitsuAC ac(kIrLed);
+
+void printState() {
+  // Display the settings.
+  Serial.println("Fujitsu A/C remote is in the following state:");
+  Serial.printf("  %s\n", ac.toString().c_str());
+  // Display the encoded IR sequence.
+  unsigned char* ir_code = ac.getRaw();
+  Serial.print("IR Code: 0x");
+  for (uint8_t i = 0; i < ac.getStateLength(); i++)
+    Serial.printf("%02X", ir_code[i]);
+  Serial.println();
+}
+
+void setup() {
+  ac.begin();
+  Serial.begin(115200);
+  delay(200);
+
+  // Set up what we want to send. See ir_Fujitsu.cpp for all the options.
+  Serial.println("Default state of the remote.");
+  printState();
+  Serial.println("Setting desired state for A/C.");
+  // See `fujitsu_ac_remote_model_t` in `ir_Fujitsu.h` for a list of models.
+  ac.setModel(ARRAH2E);
+  ac.setSwing(kFujitsuAcSwingOff);
+  ac.setMode(kFujitsuAcModeCool);
+  ac.setFanSpeed(kFujitsuAcFanHigh);
+  ac.setTemp(24);  // 24C
+  ac.setCmd(kFujitsuAcCmdTurnOn);
+}
+
+void loop() {
+  // Now send the IR signal.
+  Serial.println("Sending IR command to A/C ...");
+#if SEND_FUJITSU_AC
+  ac.send();
+#else  // SEND_FUJITSU_AC
+  Serial.println("Can't send because SEND_FUJITSU_AC has been disabled.");
+#endif  // SEND_FUJITSU_AC
+  printState();
+  delay(5000);
+}

arduino-cli/libraries/IRremoteESP8266/examples/TurnOnFujitsuAC/platformio.ini

@@ -0,0 +1,18 @@
+[platformio]
+src_dir = .
+
+[env]
+lib_extra_dirs = ../../
+lib_ldf_mode = deep+
+lib_ignore = examples
+framework = arduino
+monitor_speed = 115200
+build_flags = ; -D_IR_LOCALE_=en-AU
+
+[env:nodemcuv2]
+platform = espressif8266
+board = nodemcuv2
+
+[env:esp32dev]
+platform = espressif32
+board = esp32dev