初始化提交

arduino-cli/libraries/IRremoteESP8266/examples/TurnOnArgoAC/TurnOnArgoAC.ino

@@ -0,0 +1,56 @@
+/* Copyright 2017, 2018 crankyoldgit
+* An IR LED circuit *MUST* be connected to the ESP8266 on a pin
+* as specified by kIrLed below.
+*
+* TL;DR: The IR LED needs to be driven by a transistor for a good result.
+*
+* Suggested circuit:
+*     https://github.com/crankyoldgit/IRremoteESP8266/wiki#ir-sending
+*
+* Common mistakes & tips:
+*   * Don't just connect the IR LED directly to the pin, it won't
+*     have enough current to drive the IR LED effectively.
+*   * Make sure you have the IR LED polarity correct.
+*     See: https://learn.sparkfun.com/tutorials/polarity/diode-and-led-polarity
+*   * Typical digital camera/phones can be used to see if the IR LED is flashed.
+*     Replace the IR LED with a normal LED if you don't have a digital camera
+*     when debugging.
+*   * Avoid using the following pins unless you really know what you are doing:
+*     * Pin 0/D3: Can interfere with the boot/program mode & support circuits.
+*     * Pin 1/TX/TXD0: Any serial transmissions from the ESP8266 will interfere.
+*     * Pin 3/RX/RXD0: Any serial transmissions to the ESP8266 will interfere.
+*   * ESP-01 modules are tricky. We suggest you use a module with more GPIOs
+*     for your first time. e.g. ESP-12 etc.
+*/
+
+#include <Arduino.h>
+#include <IRremoteESP8266.h>
+#include <IRsend.h>
+#include <ir_Argo.h>
+
+const uint16_t kIrLed = 4;  // ESP8266 GPIO pin to use. Recommended: 4 (D2).
+IRArgoAC ac(kIrLed);  // Set the GPIO to be used to sending the message.
+
+void setup() {
+  ac.begin();
+  Serial.begin(115200);
+}
+
+void loop() {
+  Serial.println("Sending...");
+
+  // Set up what we want to send. See ir_Argo.cpp for all the options.
+  ac.setPower(true);
+  ac.setFan(kArgoFan1);
+  ac.setMode(kArgoAuto);
+  ac.setTemp(25);
+
+#if SEND_ARGO
+  // Now send the IR signal.
+  ac.send();
+#else  // SEND_ARGO
+  Serial.println("Can't send because SEND_ARGO has been disabled.");
+#endif  // SEND_ARGO
+
+  delay(5000);
+}

arduino-cli/libraries/IRremoteESP8266/examples/TurnOnArgoAC/platformio.ini

@@ -0,0 +1,18 @@
+[platformio]
+src_dir = .
+
+[env]
+lib_extra_dirs = ../../
+lib_ldf_mode = deep+
+lib_ignore = examples
+framework = arduino
+monitor_speed = 115200
+build_flags = ; -D_IR_LOCALE_=en-AU
+
+[env:nodemcuv2]
+platform = espressif8266
+board = nodemcuv2
+
+[env:esp32dev]
+platform = espressif32
+board = esp32dev