初始化提交

arduino-cli/libraries/IRremoteESP8266/examples/IRrecvDemo/IRrecvDemo.ino

@@ -0,0 +1,51 @@
+/*
+ * IRremoteESP8266: IRrecvDemo - demonstrates receiving IR codes with IRrecv
+ * This is very simple teaching code to show you how to use the library.
+ * If you are trying to decode your Infra-Red remote(s) for later replay,
+ * use the IRrecvDumpV2.ino (or later) example code instead of this.
+ * An IR detector/demodulator must be connected to the input kRecvPin.
+ * Copyright 2009 Ken Shirriff, http://arcfn.com
+ * Example circuit diagram:
+ *  https://github.com/crankyoldgit/IRremoteESP8266/wiki#ir-receiving
+ * Changes:
+ *   Version 0.2 June, 2017
+ *     Changed GPIO pin to the same as other examples.
+ *     Used our own method for printing a uint64_t.
+ *     Changed the baud rate to 115200.
+ *   Version 0.1 Sept, 2015
+ *     Based on Ken Shirriff's IrsendDemo Version 0.1 July, 2009
+ */
+
+#include <Arduino.h>
+#include <IRremoteESP8266.h>
+#include <IRrecv.h>
+#include <IRutils.h>
+
+// An IR detector/demodulator is connected to GPIO pin 14(D5 on a NodeMCU
+// board).
+// Note: GPIO 16 won't work on the ESP8266 as it does not have interrupts.
+const uint16_t kRecvPin = 14;
+
+IRrecv irrecv(kRecvPin);
+
+decode_results results;
+
+void setup() {
+  Serial.begin(115200);
+  irrecv.enableIRIn();  // Start the receiver
+  while (!Serial)  // Wait for the serial connection to be establised.
+    delay(50);
+  Serial.println();
+  Serial.print("IRrecvDemo is now running and waiting for IR message on Pin ");
+  Serial.println(kRecvPin);
+}
+
+void loop() {
+  if (irrecv.decode(&results)) {
+    // print() & println() can't handle printing long longs. (uint64_t)
+    serialPrintUint64(results.value, HEX);
+    Serial.println("");
+    irrecv.resume();  // Receive the next value
+  }
+  delay(100);
+}

arduino-cli/libraries/IRremoteESP8266/examples/IRrecvDemo/platformio.ini

@@ -0,0 +1,18 @@
+[platformio]
+src_dir = .
+
+[env]
+lib_extra_dirs = ../../
+lib_ldf_mode = deep+
+lib_ignore = examples
+framework = arduino
+build_flags = ; -D_IR_LOCALE_=en-AU
+monitor_speed = 115200
+
+[env:nodemcuv2]
+platform = espressif8266
+board = nodemcuv2
+
+[env:esp32dev]
+platform = espressif32
+board = esp32dev